The Pop Out Swing Card is so much fun to make and it would be so much fun to receive!

So here are several ideas with a tutorial at the end of the post.



Here is view from the top.


Start by using the #6 Square Framelit (smallest to largest) to cut out a square of the front of the card.

Be sure to open up the card before you cut it!  You only want the cut on the front.


Then score a 6"x 5" piece of white card stock at 2" and 4" and fold it like an accordian.


Put some Tear and Tape behind the right panel and carefully position it to the inside of the card like you see in the picture. There should be a nice border around all three of the sides.


Next close the card up and get ready to place the 3 1/4" square piece that you have prepared on the front.

I put the Tear and Tape along the right side of the 3 1/4" square piece and then added some regular adhesive beside it up to about half way over.


The 3 1/4" square piece will fit perfectly into the window and your card will be complete unless you also want to add some stamping to the inside of the card.


You can add any saying that will fit on a 1 3/8" circle.

Built for Free Using: My Stampin Blog


Please e-mail me if you have any questions.

Thank you for stopping by!

Thank you for stopping by. 

Please e-mail me if you have any questions or feedback